12
Receiver Mount Installation / Assembly
INSTALLING RECEIVER MOUNT MODEL: 350/350S/750R/750RS
The Blaster 350/350S/750R/750RS is a dedicated, 2", receiver (hitch) mount salt spreader. Prior to installation,
be certain that the vehicle receiver is in good working order, is rated for at least a 500 lb. tongue load, and is fastened
to the vehicle securely.
CAUTION - The spreader is a large heavy item that should be installed with an assistant. As with any new equipment
installation read and understand all instructions prior to starting the job, and do not hurry through it. A correct
in
stallation now can save time and money later.
1.
Using an assistant remove the spreader unit and all loose components from the packaging and set cover aside
until installation is complete. Retain original packaging for storage purposes.
2.
Locate the large hitch pin and cotter clip (40) from the hardware package. Set these items aside, as they will be
used later during the installation.
3.
Inspect the vehicle's receiver tube and check for rust, dirt, or foreign debris that may have collected in it. If there
are any blockages clean with compressed air and a wire brush.
4.
Apply good quality grease to the inside of the receiver tube, this will prevent rusting and make the spreader easier
to remove at the end of the season.
5.
The framework will have four 1/2-13 x 3” SS Bolts (29) already installed in the mounting holes for the stinger.
Remove the 1/2-13 SS Locknuts (30) and 1/2” SS Flatwashers (31) and apply a light oil to the threads, this will make
assembly easier; yet will not affect the locking properties of the safety nuts. Place the hitch assembly over the bolts,
replace the nuts and washers and fully tighten.
6.
Lift the spreader unit upright (hopper opening facing up) with mounting tube pointed toward the truck.
5
19
SAFETY PRECAUTIONS - See pages 5-6 for definitions
22 / 23 / 24 / 25
