13
Receiver Mount Installation / Assembly
5 / 9 / 11 / 12
19
SAFETY PRECAUTIONS - See pages 5-6 for definitions
22 / 23 / 24 / 25 / 27
7.
Slowly slide spreader mounting tube into the vehicles receiver until the through holes in receiver match through
holes
in
spreader.
(See
note
below)
8.
Insert the large hitch pin (40) through the receiver tube and spreader mounting tube. Secure with the cotter clip (40).
WARNING – The cotter clip (40) must be in place for safe operation.
9.
Place the cover over the hopper and secure clamps on left and right sides.
NOTE:
• The spreader mounting tube has two pre-punched hole sets to provide some adjustment when installing the unit.
• Always use the hole set that places the unit closest to the vehicle but without touching it.
WARNING – Never attempt to drill new holes in the spreader mounting tube, contact your local trailer hitch supplier
about relocating or replacing you current hitch, if mounting problems occur.
10.
Use the Ratchet Tie Down Strap and Tie Down Hooks to tie spreader to vehicle frame to eliminate any rocking
of the spreader.
