7-14
NORDBERG LT105/105S INSTRUCTION MANUAL
7-28-B
02/02
CHAPTER 7 - CRUSHING
7.8 CLEARING OF THE BLOCKAGE
NOTE:
Never try to clear the blockage with an
excavator.
If the process is initiated with material in the cavity,
the crusher tries to start with slow ramp and if the
rock is strong enough to prevent crusher from
starting, the alarm # 3 (“Crusher pressure rising too
fast on start”) will be shown in the display.
The process will be fully activated but the feeder
and the crusher will not function. You can swing
the crusher clockwise and counter clockwise with
the buttons 8 and 9 (fig. 7.8.1) of the remote control
box, located on the service platform.
When the cavity is clear, switch on the crusher
using the “Crusher start” -button (# 7, figure 7.8.1).
Start the feeder.
7.9 REMOVAL OF THE STEEL
Always stop the machine (feeder, crusher,
conveyors and engine) before removing metal
from it. Make sure that it can not be started during
removing metal from it.
Use a hook to remove iron bars and wires. Be very
careful not to hurt yourself. Never use a hook
when the machine is running.
Figure 7.8.1 Remote control
https://tractormanualz.com/
Summary of Contents for NORDBERG LT105
