MI 2130 VoltScanner
Plugging in the VoltScanner
16
Note:
Before using the VoltScanner for the first time, plug it in an outlet for at least 5 hours
or over night, so that batteries will charge up.
If the VoltScanner hasn’t been used for more than two months, also plug it in an
outlet for at least 5 hours or over night before using it again.
If you don’t plan to use the VoltScanner for a longer period of time, you can always
leave it plugged into the nearest outlet (no need to be set), so that the batteries will
be full when you need it.
The LEDs only blink when line voltage is present. During longer voltage interruptions
(longer than 3.5 minutes), the VoltScanner goes into power down mode in which only
Event LED blinks every 8 seconds, if there are any events stored.
