MI 2130 VoltScanner
Introduction
6
1.7 Maintenance
Batteries
! The instrument is under hazardous voltage. Disconnect all test leads before
removing battery compartment cover.
If it is necessary to replace batteries, all four MUST be replaced. Ensure that
batteries are installed with correct polarity.
Do not use nonrechargeable batteries.
There may exist special environmental regulations concerning the disposal of
batteries. If requested, follow the regulations.
Cleaning
To clean the surface of an instrument, use a soft cloth slightly moistened with soapy
water or alcohol. Then leave the instrument to dry totally before use.
•
Do not use liquids based on petrol or hydrocarbons!
•
Do not spill cleaning liquid over the instrument!
Service and ReCalibration
For repairs under warranty, recalibration of the VoltScanner, and for further information,
please contact your distributor. It is recommended that VoltScanner is recalibrated once
every two years.
Manufacturer's address:
METREL d.d.
Ljubljanska 77
SI-1354 Horjul
tel: +(386) 1 7558 200
fax: +(386) 1 7549 095
e-mail: [email protected]
internet:
