19.01.2015
Metos Induction range Dominator
9
5. INDUCTION ERROR CODES
DO NOT remove or attempt to repair/replace ANY component or part of this unit other than the air filter.
If an error occurs, the control panel LEDs will flash to indicate an error code.
One LONG flash will be followed by a series of shorter flashes. The number of “short” flashes
corresponds to a value in the “code” column of the following table.
ie. 5 short flashes corresponds to Error Code: 05 - Control Unit Failure
6. TROUBLESHOOTING
If a fault occurs during use, an error code will be displayed in a series of flashes.
These correspond to the numbers in code column of the table on Page 10.
For example, 6 short flashes followed by an extended flash indicates error code 06 (Generator internal
temperature too high).
The codes are provided to diagnose possible faults and the action required to remedy any such condition.
Note: Most faults can be rectified by simply switching the unit off for 10 seconds. After this time, turn
power back on at mains supply.
If fault continues to occur after this action then please refer to the table. It will provide the solution to
rectify the condition.
SUPPLY PROTECTION DEVICE
The appliance is fitted with a miniature circuit breaker MCB) as additional protection against over current.
If unit fails to operate or show any operational indicators, Follow details in Error Code Table before calling
a service engineer. The symptoms may indicate a failed induction generator.
