19.01.2015
Metos Induction range Dominator
11
8. CLEANING and MAINTENANCE
It is important to clean air intake filter regularly.
The filter is located below body of appliance at front and RH side. It can be removed by sliding out of
front. Clean using hot, soapy water and re-fit after drying.
9. CLEANING THE APPLIANCE
9.1. General
BEFORE ANY CLEANING OPERATION, ISOLATE ELECTRICITY AT MAIN SWITCH.
THE APPLIANCE MUST NEVER BE CLEANED WITH A JET OF WATER OR BE STEAM CLEANED.
Surfaces are easier to clean if spillage is removed before it becomes burnt on.
It is advisable to clean unit daily, after use.
Stainless Steel Surfaces
These surfaces should be cleaned with hot water and detergent then dried and polished with a soft cloth.
Cleaning agents containing bleach, abrasives or caustic chemicals will damage or stain the stainless steel
surfaces and must not be used.
Vitreous Enamel Surfaces
Approved cleaning agents which bear the Vitreous Enamel Development Centre (VEDC) mark are recom-
mended.
Wipe enamelled surfaces clean while still warm. Use a soft cloth and hot soapy water.
Badly stained, removable parts should be soaked in hot water with an approved detergent.
If parts are not able to be removed, the application of warm water with approved detergent using nylon
or scotch cleaning pads will provide good results.
Ceran-glass Hob
Clean glass with hot soapy water and a soft cloth.
Do NOT use metal scrapers.
