ADDENDUM B page
5
DWG # 2
3.
Using a 0.05 hex wrench perform tasks A through F.
DWG # 3
A.
Turn both screws C & D counterclockwise until there is no
effect of this action on the screen. (The image does not move.)
B.
Turn screw D clockwise until the image on the screen starts to move
and turn an additional 65
°
±
10
°
from this point.
Repeat this step for screw C.
C.
Turn both screws E & F counterclockwise until there is no effect of
this motion on the image on the screen. (The image does not shift.)
D.
Turn screw F clockwise until the vertical lines of the component on
the PCB blank are lined up and continuous, not broken.
E.
Turn screw E clockwise until the horizontal lines of the component
on the PCB blank are lined up and continuous, not broken. If you cannot line up the
horizontal lines turn the split adjustment knob and additional 10
°
- 15
°
.
F.
Turn split vision knob clockwise 45
°
and back counterclockwise
until the outline lines up again in both vertical and horizontal
directions. The image should look as in DWG # 4 on the right. If the image looks like
the one on the left, repeat steps A-F.
DWG # 4
Turn the split vision knob clockwise and counterclockwise to ensure that both
corners move toward each other and back and proper alignment is kept.
SCREEN SPLITTING
LINE
A
B
