Meta System ARCHIMOD 100, Operating And Maintenance Manual, Page: 59 / 72

8-4
Operating and Maintenance Manual
Diagnostics
code 504275001 Rev. September 2010
SIGNALLING EVENTS
Message Meaning
SHUTTING DOWN DUE TO END OF
AUTONOMY UPS shut down due to the end of autonomy.
SHUTTING DOWN DUE TO INCOR-
RECT THREE-PHASE SEQUENCE UPS shut down due to an incorrect three-phase sequence in input.
START-UP WITH BATTERY FAILED Start-up with battery failed.
BATT.CAL.INTERRUPTED Battery calibration interrupted.
MAXIMUM TIME ON BATTERY Maximum time on battery.
MAXIMUM TIME ON RESERVE Maximum time on autonomy reserve.
START-UP ERROR Error in starting up.
START-UP AUTHORISED WHEN
THERE ARE ONGOING ALARMS UPS start-up authorised in the presence of alarms.
STARTUP AUTHORISED WITH A
NEW CONFIG. UPS start-up authorised with a new con fi guration.
SHUTTING DOWN DUE TO INCOR-
RECT CONFIGURATION UPS shutting down due to an incorrect con fi guration.
POWER MODULE FW UPDATE The Power Module Firmware updated.
INFORMATION EVENTS
Message Meaning
STARTUP BY USER N UPS start-up by user.
SHUTTING DOWN BY USER UPS shut down by user.
AUTOMATIC STARTUP: Automatic UPS start-up.
DELAYED SHUTTING DOWN The UPS was shut down by programming a delayed shutdown.
BATTERY CHARGER START IN
STAND-BY The battery charger started in standby.
UPS ON BATTERY UPS on battery.
UPS ON MAINS UPS on mains.
OUTPUT OFF The output is off
BATTERY TEST \NEXECUTED Batteries tested.
BATTERIES CALIBRATED Batteries calibrated.
ALARMS
Message Meaning
INVERTER FAILURE Failure occurred in the Inverter circuit.
BOOSTER FAILURE Failure occurred in the Booster circuit.
BATTERY CHARGER FAILURE Failure occurred in the Battery Charger circuit.
OVERHEATING Overheating. Check the UPS ventilation system.
OVERLOAD Overload. Check the load level connected to the UPS.
HVBUS RUNAWAY Anomalous high voltage on the DC BUS.
EXC. IN OUT DC LEVEL Excessive DC voltage in output.
EXCESS.BATTERY V Battery voltage too high.
MODULE COMMUNICATION FAILED Failure of the communication system with the Power Modules.
LOAD NOT PROTECTED
Load not protected by the UPS
LAST LINE ON THE MAIN ‘BATTERY’ FRAME
Message Meaning
BATTERIES ON STAND-BY Batteries on stand-by.
RUNNING DOWN Batteries running down.
AUTONOMY RESERVE Autonomy reserve.
END OF AUTONOMY End of autonomy, UPS shutting down.
CHARGING – F1 Battery recharging status: Phase 1
CHARGING – F2 Battery recharging status: Phase 2
CHARGING – MAINT. Recharging batteries in maintenance.
BATTERIES BEING TESTED Batteries being tested.
BATTERY EQUALIS. Batteries being equalised.
BATTERIES FAILED Batteries failed.