MAINTENANCE
90-826883R2 JUNE 1998
Page 1B-5
4. Adjust water flow (if necessary) so excess water continues leaking out from around
the rubber cups to ensure the engine is receiving an adequate supply of cooling water.
5. Check for a steady stream of water flowing out of the water pump indicator hole. Con-
tinue flushing the outboard for 3 to 5 minutes, carefully monitoring water supply at all
times.
6. Stop the engine, turn off the water, and remove the flushing attachment. Reinstall the
propeller.
Fuel System
WARNING
Avoid serious injury or death from gasoline fire or explosion. Carefully follow all
fuel system service instructions. Always stop the engine and DO NOT smoke or
allow open flames or sparks in the area while servicing any part of the fuel sys-
tem.
Before servicing any part of the fuel system, stop engine and disconnect the battery. Drain
the fuel system completely. Use an approved container to collect and store fuel. Wipe up
any spillage immediately. Material used to contain spillage must be disposed of in an ap-
proved receptacle. Any fuel system service must be performed in a well ventilated area.
Inspect any completed service work for sign of fuel leakage.
Fuel Line Inspection
Visually inspect the fuel line and primer bulb for cracks, swelling, leaks, hardness or other
signs of deterioration or damage. If any of these conditions is found, the fuel line or primer
bulb must be replaced.
Engine Fuel Filter
Inspect the sight bowl for water accumulation and inspect the filter element for sediment.
Clean filter as follows.
REMOVAL
1. Hold onto the cover to prevent it from turning.
2. Turn off the sight bowl.
3. Pull out the filter element and wash it with cleaning solvent.