Mercury Racing VesselView, Installation, Calibration & Operation Manual

Page: 44 / 190

Section 2 - Initial Setup and Calibration
90-8M8022154 APRIL 2008 Page 37
1. Press the check button to enter tab setup.
32786
2. Press the left or right arrow on the arrow trackpad to identify how many tabs are installed
on the vessel. If there are no tabs installed, press the
X
button to go back one step to
the "TAB SETUP" screen and continue to step 22.
NOTE: The "TABS" screen will add fields to the screen depending on the quantity of tabs
selected. If one tab is identified then a "CENTER" field will appear. If two tabs are identified,
as shown, then a "STBD TAB" field and a "PORT TAB" field will appear.
32866
3. Press the down arrow on the arrow trackpad to select the next field.
4. Press the left or right arrow on the arrow trackpad to identify what engine the tab is
connected to.
5. If there are multiple tabs, press the down arrow on the arrow trackpad to proceed to
the next field.
6. Press the left or right arrow on the arrow trackpad until the proper wire connection to
the engine is shown.
7. Confirm your selections by pressing the check button.