Mercury Racing VesselView, Installation, Calibration & Operation Manual

Page: 31 / 190

Section 2 - Initial Setup and Calibration
Page 24 90-8M8022154 APRIL 2008
NOTE: Select the "UNIQUE VESSELVIEW ID" by the position the VesselView units are
installed (lowest to highest helm is recommended).
a
b
27075
a - VesselView ID
b - Helm ID
2. Press the right arrow on the arrow trackpad to increase the number or the left arrow to
decrease the number. Choose a number that is different from the number assigned to
any other VesselView unit installed.
3. Press the down arrow on the arrow trackpad to proceed to the "HELM ID" field.
NOTE: Use "HELM ID 1" for single helm vessels. If a vessel has multiple VesselView units
installed on different helms (up to four maximum) the "HELM ID" needs to represent the
helm where each VesselView is installed (lowest to highest helm is recommended).
4. Press the left or right arrow on the arrow trackpad to choose either helm 1, helm 2,
helm3, or helm 4.
5. Confirm your selections by pressing the check button.
6. Press the right arrow on the arrow trackpad to continue to the "TANK SETUP" screen.
Tank Setup and Calibration
The "TANK SETUP" screen enables you to enter the capacity and location of tanks on the
vessel. Each tank can be defined as either fuel, oil, water, or waste. Depending on the
engine configuration, additional tank fields will become available.
32780