Mercury Racing VesselView, Installation, Calibration & Operation Manual

Page: 105 / 190

Section 4 - Main Menu
Page 98 90-8M8022154 APRIL 2008
NOTE: The fuel tank offset can only be a positive offset.
5. After you have made the necessary changes to the tank offset, press the down arrow
on the arrow trackpad to proceed to the "SEA TEMP OFFSET" field.
6. The sea temperature default setting is 0 degrees. Take the actual seawater
temperature and subtract the displayed sea temperature. Then either add or subtract
the difference in temperature in the "SEA TEMP OFFSET" field using the left or right
arrow on the arrow trackpad.
7. Once you have finished making changes to the offsets, press the check button to save
the session.
NOTE: Upon completing any change/customization to VesselView a blue pop‑up message
will appear as a reminder to save your session. Refer to
Section 1 - Saving Settings
. To
save time, it is recommended that all session changes be saved before holding
X
button
while keying ALL engines off.
Settings 2
Settings 2 Menu Options
The "Settings 2" menu enables you to personally customize VesselView. The "Settings 2"
menu items include the following:
33856
Main
Calibrate
Settings
Settings 2
Alarms
System Info
Tech
Settings 2
Tabs
Trim/Tab Popup
Hot Keys
Pages On/Off
NOTE: Upon completing any change/customization to VesselView a blue pop‑up message
will appear as a reminder to save your session. Refer to
Section 1 - Saving Settings
. To
save time, it is recommended that all session changes be saved before holding
X
button
while keying ALL engines off.
Tabs
This "Tabs" menu option is provided so that you have direct access to modify the tab
settings. Upon entering from the "Tabs" menu option you are directed to the "TABS" screen
that contains the tab configuration settings. This enables you to turn off individual tabs or
change the wiring configuration without having to go through the setup wizard. Calibration
is offered if you are adding a tab into the configuration. This "TABS" screen utilizes the
same screens for calibration that both the setup wizard and the "Tab Calibration" procedure
use. Menu path: "Main" > "Settings 2" > "Tabs". Press the check button to open the "TABS"
screen.