Mercury Racing VesselView, Installation, Calibration & Operation Manual

Page: 176 / 190

Section 8 - Installation and Wiring
90-8M8022154 APRIL 2008 Page 169
Installing the NMEA 0183 Adapter Harness
x VesselView
SmartCraft
24134
a
b
c
d
e
f
g
h
i
j
l m
n
k
o
a - 10‑pin connector
b - Multi‑ignition connector
c - Warning horn
d - NMEA output connector (light blue with green stripe: NMEA out [+]; dark blue
with red stripe: NMEA out [–])(reserved for future use)
e - NMEA input connector (white with dark blue stripe: NMEA in [+]; dark blue
with white stripe: NMEA in [–])
f - NMEA adapter harness
g - Port inner (engine 4) system link gauge connector (purple and red wires)
h - Starboard inner (center/engine 3) system link gauge connector (purple and
tan wires)
i - VesselView
j - VesselView connectors
k - NMEA 0183 connector
l - Starboard (engine 1) system link gauge connector (purple wires)
m - Port (engine 2) system link gauge connector (purple and yellow wires)
n - Air temperature sensor connector
o - VesselView harness
1. Connect the 5‑pin NMEA connector on the adapter harness to the 5‑pin NMEA 0183
connector on the VesselView harness as shown in the diagram.
2. Connect your GPS unit or other NMEA‑compatible device to the adapter harness.