Mercedes-Benz Mercedec-AMG GT R, Owner'S Manual

Page: 131 / 441

R
The vehicle as well as persons and objects
are located outside the range of movement
of the door.
#
Press the programming button on the door
drive unit.
Initiate the next step within approximately
30 seconds.
#
Press previously programmed button 2 , 3
or 4 repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
% Please also read the operating instructions
for the door drive.
Troubleshooting when programming the
remote control
#
Check if the transmitter frequency of remote
control 5 is supported.
#
Replace the batteries in remote control 5 .
#
Hold remote control 5 at various angles
from a distance of 1 cm to 8 cm front of the
inside rearview mirror. You should test every
position for at least 25 seconds before trying
another position.
#
Hold remote control 5 at the same angles
at various distances in front of the inside
rearview mirror. You should test every posi‐
tion for at least 25 seconds before trying
another position.
#
On remote controls that transmit only for a
limited period, press button 6 on remote
control 5 again before transmission ends.
#
Align the aerial line of the door opener unit
with the remote control.
% Support and additional information on pro‐
gramming:
R
on the HomeLink
®
Hotline on
(0) 08000 466 354 65 or
+49 (0) 6838 907 277
R
on the Internet at https://
www.homelink.com
Opening or closing the garage door
Requirements:
R
The corresponding button is programmed to
operate the door.
#
Press and hold buttons 2 , 3 or 4 until
the door opens or closes.
#
If indicator lamp 1 flashes yellow after
approximately 20 seconds: press and hold
the previously pressed button again until the
door opens or closes.
Clearing the garage door opener memory
#
Press and hold buttons 2 and 4 .
Indicator lamp 1 lights up yellow.
#
If indicator lamp 1 flashes green: release
buttons 2 and 4 .
The entire memory has been deleted.
128 Driving and parking