Mercedes-Benz GT S 2016, Operator'S Manual

Page: 198 / 270

Problems when programming
If you are experiencing problems programing
the integrated garage door opener on the
rear-view mirror, take note of the following
instructions:
R
Check the transmitter frequency used by
garage door drive remote control
A
and
whether it is supported. The transmitter
frequency can usually be found on the back
of the garage door drive remote control.
The integrated garage door opener is com-
patible with devices that have units which
operate in the frequency range of 280 to
433 MHz.
R
Replace the batteries in garage door
remote control
A
. This increases the like-
lihood that garage door remote control
A
will transmit a strong and precise signal to
the integrated garage door opener.
R
When programming, hold remote control
A
at varying distances and angles from the
button which you are programming. Try var-
ious angles at a distance between 2and
12 inches (5to 30 cm) or at the same angle
but at varying distances.
R
If another remote control is available for the
same garage door drive, repeat the same
programming steps with this remote con-
trol. Before performing these steps, make
sure that new batteries have been installed
in garage door drive remote control
A
.
R
Note that some remote controls only trans-
mit for a limited amount of time (the indi-
cator lamp on the remote control goes out).
Press button
B
on remote control
A
again
before transmission ends.
R
Align the antenna cable of the garage door
opener unit. This can improve signal recep-
tion/transmission.
Opening/closing the garage door
After it has been programmed, the integrated
garage door opener assumes the function of
the garage door system's remote control.
Please also read the operating instructions
for the garage door system.
X
Select SmartKey position 2 with the Start/
Stop button (
Y
page 100).
X
Press button
;
,
=
or
?
that has been
programmed to operate the garage door.
Garage door system with a fixed code: indi-
cator lamp
:
lights up green.
Garage door system with a rolling code:
indicator lamp
:
flashes green.
The transmitter will transmit a signal as
long as the button is pressed. The trans-
mission is halted after a maximum of ten
seconds and indicator lamp
:
lights up
yellow.
X
Press button
;
,
=
or
?
again if neces-
sary.
Clearing the memory
Make sure that you clear the memory of the
integrated garage door opener before selling
the vehicle.
X
Select SmartKey position 2 with the Start/
Stop button (
Y
page 100).
X
Press and hold buttons
;
and
?
.
The indicator lamp initially lights up yellow
and then green.
X
Release buttons
;
and
?
.
The memory of the integrated garage door
opener in the rear-view mirror is cleared.
Floormats
G WARNING
Objects in the driver's footwell can restrict the
pedal travel or obstruct a depressed pedal.
The operating and road safety of the vehicle is
jeopardized. There is a risk of an accident.
Make sure that all objects in the vehicle are
stowed correctly, and that they cannot enter
the driver's footwell. Install the floormats
securely and as specified in order to ensure
sufficient clearance for the pedals. Do not use
196
Features
Stowage
and
featu
res