Mercedes-Benz GT S 2016, Operator'S Manual

Page: 196 / 270

Important safety notes
G WARNING
When you operate or program the garage door
with the integrated garage door opener, per-
sons in the range of movement of the garage
door can become trapped or struck by the
garage door. There is a risk of injury.
When using the integrated garage door
opener, always make sure that nobody is
within the range of movement of the garage
door.
G WARNING
Combustion engines emit poisonous exhaust
gases such as carbon monoxide. Inhaling
these exhaust gases leads to poisoning. There
is a risk of fatal injury. Therefore never leave
the engine running in enclosed spaces with-
out sufficient ventilation.
Programming
Programming buttons
Pay attention to the "Important safety notes"
(
Y
page 194).
Garage door remote control
A
is not inclu-
ded with the integrated garage door opener.
X
Select SmartKey position 2 with the Start/
Stop button (
Y
page 100).
X
Select one of buttons
;
to
?
to use to
control the garage door drive.
X
To start programming mode: press and
hold one of buttons
;
to
?
on the inte-
grated garage door opener.
The garage door opener is now in program-
ming mode. After a short time, indicator
lamp
:
lights up yellow.
Indicator lamp
:
lights up yellow as soon
as button
;
,
=
or
?
is programmed for
the first time. If the selected button has
already been programmed, indicator
lamp
:
will only light up yellow after ten
seconds have elapsed.
X
Release button
;
,
=
or
?
. Indicator
lamp
:
flashes yellow.
X
To program the remote control: point
garage door remote control
A
towards
buttons
;
to
?
on the rear-view mirror at
a distance of 2 to 8 inches (5 to 20 cm).
X
Press and hold button
B
on remote control
A
until indicator lamp
:
lights up green.
When indicator lamp
:
lights up green:
programming is finished.
When indicator lamp
:
flashes green: pro-
gramming was successful. The next step is
to synchronize the rolling code
(
Y
page 194).
X
Release button
B
on remote control
A
for
the garage door drive system.
If indicator lamp
:
lights up red: repeat the
programming procedure for the corre-
sponding button on the rear-view mirror.
When doing so, vary the distance between
remote control
A
and the rear-view mirror.
The required distance between remote
control
A
and the integrated garage door
opener depends on the garage door drive
system. Several attempts might be neces-
sary. You should test every position for at
least 25 seconds before trying another
position.
Synchronizing the rolling code
Pay attention to the "Important safety notes"
(
Y
page 194).
If the garage door system uses a rolling code,
you will also have to synchronize the garage
194
Features
St
owage
and
fea
tu
re
s