Mercedes-Benz E-Class Saloon, Owner'S Manual

Page: 196 / 612

#
Point remote control 5 from a distance of
1 cm to 8 cm towards buttons 1 , 2 or 3 .
#
Press and hold button 6 of remote control
5 until one of the following signals appears:
R
Indicator lamp 4 lights up green contin‐
uously. Programming is complete.
R
Indicator lamp 4 flashes green. Pro‐
gramming was successful. Additionally,
synchronisation of the rolling code with
the door system must also be carried out.
#
If indicator lamp 4 does not light up or flash
green: repeat the procedure.
#
Release all of the buttons.
% The remote control for the door drive is not
included in the scope of delivery of the
garage door opener.
Synchronising the rolling code
Requirements:
R
The door system uses a rolling code.
R
The vehicle must be within range of the
garage door or door drive.
R
The vehicle as well as persons and objects,
are located outside the range of movement
of the door.
#
Press the programming button on the door
drive unit.
Initiate the next step within approximately
30 seconds.
#
Press previously programmed button 1 , 2
or 3 repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
% Please also read the operating instructions
for the door drive.
Troubleshooting when programming the
remote control
#
Check if the transmitter frequency of remote
control 5 is supported.
#
Replace the batteries in remote control 5 .
#
Hold remote control 5 at various angles at
a distance between 1 cm to 8 cm in front of
194 Driving and parking