Mercedes-Benz E 350 BlueEFFICIENCY Cabriolet, Operator'S Manual

Page: 291 / 372

same programming steps with this remote
control. Before performing these steps,
make sure that new batteries have been
installed in garage door drive remote
control
A
.
R
Note that some remote controls only
transmit for a limited amount of time (the
indicator lamp on the remote control goes
out). Press button
B
on remote control
A
again before transmission ends.
R
Align the antenna cable of the garage door
opener unit. This can improve signal
reception/transmission.
Opening/closing the garage door
After it has been programmed, the integrated
garage door opener performs the function of
the garage door system remote control.
Please also read the operating instructions
for the garage door system.
X
Turn the SmartKey to position 2 in the
ignition lock.
X
Press button
;
,
=
or
?
which you have
programmed to operate the garage door.
Garage door system with a fixed code:
indicator lamp
:
lights up green.
Garage door system with a rolling code:
indicator lamp
:
flashes green.
i
The transmitter will transmit a signal as
long as the button is pressed. The
transmission is halted after a maximum of
ten seconds and indicator lamp
:
lights
up yellow. Press button
;
,
=
or
?
again
if necessary.
Clearing the memory
X
Turn the SmartKey to position
2 in the
ignition lock.
X
Press buttons
;
and
?
.
The indicator lamp lights up yellow.
X
Press and hold buttons
;
and
?
until the
indicator lamp turns green.
i Make sure that you clear the memory of
the integrated garage door opener before
selling the vehicle.
Compass
Calling up the compass
To receive a correct display in rear-view
mirror
:
, the compass must be calibrated
and the magnetic field zone set.
X
Briefly press button
=
.
Compass
;
displays in which compass
direction the vehicle is currently traveling:
N
,
NE
,
E
,
SE
,
S
,
SW
,
W
or
NW
.
Features
289
Stowage and features
Z