Mercedes-Benz E 350 BlueEFFICIENCY Cabriolet, Operator'S Manual

Page: 129 / 372

You can use this function to set the
headlamps to change between low beam and
high beam automatically. The system
recognizes vehicles with their lights on, either
approaching from the opposite direction or
traveling in front of your vehicle, and
consequently switches the headlamps from
high beam to low beam.
The system automatically adapts the low-
beam headlamp range depending on the
distance to the other vehicle. Once the
system no longer detects any other vehicles,
it reactivates the high-beam headlamps.
The system's optical sensor is located behind
the windshield near the overhead control
panel.
Switching Adaptive Highbeam Assist
on/off
:
High-beam headlamps
;
Turn signal, right
=
High-beam flasher
?
Turn signal, left
X
To activate: activate the Adaptive
Highbeam Assist function using the on-
board computer (
Y
page 224).
X
Turn the light switch to
Ã
.
X
Press the combination switch beyond the
pressure point in the direction of
arrow
:
.
The
_
indicator lamp in the
multifunction display lights up if it is dark
and the light sensor activates the low-beam
headlamps.
If you drive at speeds above approximately
28 mph (45 km/h):
the headlamp range is set automatically
depending on the distance between the
vehicle and other road users.
If you are driving at speeds above
approximately 35 mph (55 km/h) and no
other road users have been detected:
the high-beam headlamps are switched on
automatically. The
K
indicator lamp in
the instrument cluster also lights up.
If you drive at speeds below approximately
30 mph (45 km/h) or if other road users
are identified or if the roads are sufficiently
illuminated:
the high-beam headlamps are switched off
automatically. The
K
indicator lamp in
Exterior lighting
127
Lights and windshield wipers
Z