Mercedes-Benz 2007 C 230, Operator'S Manual

Page: 258 / 441

257
Controls in detail
Useful features
button
6
for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this se-
quence on the hand-held remote con-
trol until the frequency signal has been
learned. Upon successful training, indi-
cator lamp
1
will flash slowly and then
rapidly after several seconds.
왘
Proceed with programming step 5 and
step 6 to complete.
Reprogramming a single signal trans-
mitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
왘
Switch on the ignition (
컄
page 32).
왘
Press and hold the desired signal
transmitter button (
2
,
3
or
4
).
Do not release the button.
왘
Indicator lamp
1
will begin to flash af-
ter 20 seconds. Without releasing the
signal transmitter button, proceed with
programming starting with step 3.
Operation of integrated remote control
왘
Switch on the ignition (
컄
page 32).
왘
Select and press the appropriate
integrated signal transmitter button
(
2
,
3
or
4
) to activate the remote
controlled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
왘
Switch on the ignition (
컄
page 32).
왘
Simultaneously press and hold outer
signal transmitter buttons
2
and
4
,
for approximately 20 seconds, until
indicator lamp
1
flashes rapidly. Do
not hold for longer than 30 seconds.
The codes of all three channels are
erased.
i
Upon completion of programming the inte-
grated remote control, make sure you retain the
hand-held remote control that came with the ga-
rage door opener, gate operator or other device.
You may need it for use in other vehicles, for fu-
ture programming of an integrated remote con-
trol, or simply for continued use as a hand-held
remote control to operate the respective device
in other situations.
i
If you sell your vehicle, erase the codes of all
three channels.