Mercedes-Benz 2001 C 320, Operator'S Manual

Page: 274 / 474

273
Controls in detail
Useful features
Step 9:
왘
Press “training” button on the garage
door opener motor head unit.
The “training light” is activated.
You have 30 seconds to initiate the
following step.
Step 10:
왘
Firmly press, hold for two seconds and
release the programmed integrated
signal transmitter button (
2
,
3
or
4
).
Step 11:
왘
Press, hold for two seconds and
release same button a second time to
complete the training process.
Some garage door openers (or other rolling
code equipped devices) may require you to
perform this procedure a third time to
complete the training.
Step 12:
왘
Confirm the garage door operation by
pressing the programmed integrated
signal transmitter button (
2 , 3
or 4 ).
Step 13:
왘
To program the remaining two buttons,
repeat the steps above starting with
step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the inte-
grated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
왘
Continue to press and hold the inte-
grated signal transmitter button (
2
,
3
or
4
) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter
6
every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp
1
will flash slowly and
then rapidly after several seconds.
왘
Proceed with programming step 5 and
step 6 to complete.
Operation of integrated remote control
왘
Switch on the ignition.
왘
Select and press the appropriate inte-
grated signal transmitter button (
2
,
3
or
4
) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.