Menzi Muck Menzi IHI 45v4, Operator'S Manual

Page: 83 / 147

OPERATION
45V4 • 55V4 • 60V4 ENG 2-51
LIFTING THE MACHINE
x
Always lift the machine on a flat and firm ground.
x
Never lift the machine loaded with any personnel.
x
Make sure the lifting cables and other lifting devices are strong enough to support the
machine.
x
Do not perform crane operation including slinging work unless you are not qualified.
1. Set the blade at the rear position.
2. Raise the blade to the highest position.
3. Raise the boom to the highest position and fold the
arm and bucket fully.
4. Make the boom straight if it has swung to the right or
left.
5. Fasten wire ropes to the lifting holes at the back of the
boom using the shackle.
6. Stop the engine and get off the machine.
7. Fasten the wire ropes to the lifting holes at both ends
of the blade using shackles.
8. Apply the wire ropes from the boom and blade to the
hook of the crane. Apply patches to the positions
where the wires contact with the machine when
tensioning the wires.
9. Lift the machine slowly until it is lifted slightly apart
from the ground, stop lifting once, check the machine
balance, and lift the machine to the intended height.
Wire length: 1.5 m
Wire length: 4.0 m
(two wires)
Boom lifting hole
Blade lifting hole