Menzi Muck Menzi IHI 45v4, Operator'S Manual

Page: 110 / 147

MAINTENANCE
45V4 • 55V4 • 60V4 ENG 3-24
Check and Clean Water Separator and Replace Element
Check and Discharging Water
If the float (1) of the water separator is floating, water
reaches the bottom of the float.
When the water separator warning indicator on the OK
monitor turns on, the water separator contains the
specified amount of water.
Discharge the water.
1. Close the fuel cock (3).
2. Open the drain plug (4) to discharge water and foreign
matters to the container.
3. Close the drain plug.
4. Open the fuel cock as before.
5. Discharge air from the water separator.
6. Make sure that no fuel leaks.
Cleaning and Replacing
1. Close the fuel cock.
2. Disconnect the wiring connector.
3. Open the drain plug to discharge water and foreign
matters to the container.
4. Turn the cup (5) counterclockwise to detach it.
5. Take out the float (1) from inside of the cup.
6. Discharge water and sediment from inside of the cup
into the container.
7. Clean the element (2) and inside of the cup completely
with fresh fuel. Replace the element if it is flawed or
damaged.
8. Attach the element and O-ring to the body.
If the O-ring is damaged, replace it with a new one.
9. Put the float in the cup.
10. Turn the cup clockwise to attach it to the body. Be sure
to tighten it by hand.
11. Close the drain plug.
12. Connect the wiring connector.
13. Open the fuel cock as before.
14. Discharge air from the water separator.
15. Make sure that no fuel leaks.
Water separator
Wiring
connector
Close
Open
Water separator
Water separator warning indicator
OK monitor