MEMOLUB
®
HPS
Maintenance Adapter Instructions
MAINADAPT-0103-PG1 Copyright © 2003 PLI, LLC All Rights Reserved
Brass MEMO Fitting
Timing Ring Holder
Grease Fitting
Maintenance Adapter
Pre-charging and Annual Maintenance of Lubrication Systems
The Maintenance Adapter can be used to “pre-charge” a remote line or a distribution block
and its associated lines. This pre-charge procedure may become necessary during initial
equipment installation or when changing the type of grease being used. It can also be used to
conveniently add grease to a bearing on which the MEMO has already been installed. The
Maintenance Adapter has a M12 x 1.50 female thread, which matches the male thread of the
brass MEMO fitting.
The Maintenance Adapter is also useful in flushing old grease from remote lines and
distribution systems. It is recommended that this procedure be performed on an annual basis
to eliminate the potential problems associated with grease/oil separation that can occur with
some greases.
MEMOLUB
®
Multi-Point Systems ordered as a Plug’n Lube™ system, with tubing that has
been pre-filled at the factory, already contains the correct lubricant and does not require filling
in the field during installation.
Note
: The Maintenance Adapter is not to be used with the 2-Point Splitter System. Please
refer to
Section 3.3
for information on the proper procedure to be used in priming the Splitter-
MEMO.
If additional Maintenance Adapters are needed they can be ordered as part number:
OPMAINTADPT
MEMOLUB
®
HPS User's Guide
Page 31 of 39
PLI, LLC
