2 Point Distribution
Size Distribution
Block To Use
4 Point
Use 4 Point Block
2 Horizontal Couplers
6 Point
Use 6 Point Block
1 Horizontal Coupler
2 Vertical Couplers
3 Point Distribution
4 Point Distribution
4 Point
Use 4 Point Block
5 Point Distribution
6 Point
Use 6 Point Block
1 Vertical Coupler
6 Point Distribution
6 Point
Use 6 Point Block
Size Distribution
Block To Use
8 Point
8 Point
Use 8 Point Block
1 Vertical Coupler
Use 8 Point Block
Use 12 Point Block
3 Vertical Couplers
Use 12 Point Block
2 Vertical Couplers
Use 12 Point Block
1 Vertical Coupler
Use 12 Point Block
12 Point Distribution
11 Point Distribution
10 Point Distribution
9 Point Distribution
8 Point Distribution
7 Point Distribution
12 Point
12 Point
12 Point
12 Point
On each complete cycle of the Distribution Block, each output port ejects .3 cc's of lubricant. When 2 output ports are coupled using
either the horizontal or vertical coupler, one of the output ports is blocked and its output diverted to the second port.
The bearing
that is connected to a coupled output port receives the lubricant from both ports or .6 cc's per cycle of the Distribution Block.
The actual volume of lubricant flowing from each output port during the period of one day is controlled by the amount of lubricant that
has been programmed to be ejected by the MEMOLUB Lubricator. To program the MEMOLUB to eject the required volume of
lubricant for a multi-point application, it is necessary to determine the daily volume of grease required by all of the bearings attached
to the system. To do this, multiply the requirement for one bearing times the number of output ports on the system. This is the daily
output that the MEMOLUB must be programmed to deliver. Bearing lubricant requirements are generally stated in cubic centimeters
over some fixed interval of time.
It is important to remember that each bearing on the system will receive an equal amount of grease unless that bearing is receiving
lubricant from an output port that has been coupled, in which case it will receive twice as much grease as a bearing that has not been
coupled.
For additional assistance in planning your multi-point application or for information on programming the MEMOLUB Lubricator,
please contact PLI, LLC.
MEMOLUB "Plug and Lube" Multi-point Lubrication Systems may be ordered completely set up, preprogrammed and ready to install
with pre-filled lube lines. Call for more information.
MEMOLUB HPS
®
MPS Set-Up Guide
MPS_SUUG Copyright © 2001 PLI, LLC All Rights Reserved
Just
"Plug 'n Lube"™
Multi-Point Lubrication Distribution Block Set-Up
MEMOLUB® HPS User’s Guide
Page 28 of 39
PLI, LLC
MEMOLUB® HPS User’s Guide
Page 28 of 39
PLI, LLC
