•
Prime the MEMOLUB
®
HPS (if
necessary) with a hand grease gun.
This
step is required only if the MEMOLUB
®
was permitted to operate without a
cartridge in place or operate with an
empty cartridge.
Do this by placing the
outlet of the hand grease gun on the inlet
of the MEMOLUB
®
HPS and pumping
until grease appears at the outlet end of
the MEMOLUB
®
HPS. Two pumps of
grease are generally sufficient.
•
Lift the black rubber seal back to reveal the
battery chamber, and insert the battery pack
into the red housing by holding it by its
strip. The battery pack has to be inserted
according to the instructions on the red
housing. When the battery pack is inserted,
the motor will be activated for a second.
Put the rubber seal back in place. {
Note:
The black rubber seal is not used on the
Model 480, Giga lubricator.}
•
Remove the paper, disk-shaped label from
the replacement cartridge and fill in the
following sections: “Start Date” and
“Change Date”. The change date is
determined by the programming, which can
be looked up on your programming chart.
Place the label on the inside top surface of
the transparent housing, so that the
information can be viewed from the top of
the lubricator.
•
Carefully squeeze air out of the cartridge
until grease begins to emerge from the
outlet. This step avoids pump airlock and
ensures an uninterrupted flow of grease to
the piston pump.
MEMOLUB
®
HPS User’s Guide
Page
15 of 39
PLI,
LLC