Seite 4 von 20
2.
Wait for the printer to stop processing and the toolbox write out the printer not
responding.
3.
Switch off the mains switch.
CAUTION
Whenever powering down the unit NEVER:
1.) Never remove the power cable during the shutdown process!
2.) Never switch off the printer with the Main Power Button when the engine is still running!
Printer Buttons
Power button /green LED/
When switching on the mains switch the booting starts and the green LED illuminate. The power
button is for shutting down the print engine. After the shut-down-process the LED goes out and
you can the printer switch off with the mains switch.
The green LED always should light when the machine is ON.
Cancel button /red LED/
This button can cancel the job while the printing. The LED is only working if the button is pressed
or some errors have occurred.
Feed button /yellow LED/
Before printing you should feed the media into the machine. Advice: place the media to the left
side of the machine because the print engine has the gap and blackmark sensors also there. The
LED is only flashing if the button is pressed or some errors have occurred.
LED table:
Green LED: power status
LED ON: Engine ON
LED OFF: Engine OFF
Red LED: cancel job / clear error
LED OFF: normal operation -> button press will cancel current job
LED ON: error detected -> button press will start the clear error procedure, further error info
can be denoted by the yellow LED’s state described below
LED flashing: doing work (cancelling or clearing error)
