Seite 5 von 20
Yellow LED: feed / unfeed
Button press will initiate feed or unfeed process depending on the current paper state of the
printer.
LED flashing: doing work (feeding or unfeeding)
LED ON + red LED ON: engine in paperpath related error state, denotes paperjam in 95% of
the time
LED fl red LED ON: engine in paperpath_end_of_roll error state, so there is no paper
in the printer or it is unable to detect it
Setting up the Printer
After the printer has passed inspection, install the printhead, and the ink cartridges, as
explained in the following sections.
To set up the printer you need to do the following:
1.
Install the ink cartridges
2.
Install the printhead
3.
Turn on the Printer
4.
Load label media
5.
Install the printer driver
Installing Ink Cartridges
The iCUBE-Series-Printers use a single Printhead Cartridge and five ink tanks (two black,
one cyan, magenta and yellow). During installing the ink cartridges the Printer should be
turned off.
•
Remove the ink tanks from the shipping box.
•
Open the ink tank latches in the front of the printer by pushing the bottom of the
latch upward. The latch has a marker for signalling the place of the C, M, Y and K
tanks. (
The reason why K is used for black: in RBG color mode B is reserved for blue
)
•
Locate the place where each tank should go than slowly but firmly push the tank into
the tank socket. The pressure in the ink tanks and the septums may prevent the
cartridge to fully engage for the first insertion.
