Member's Mark G70302, Assembly Instructions & User Manual

Page: 8 / 40

1-833-454-0864
8
SAFETY HOSE AND REGULATOR
DANGER
Do not insert any tool or foreign object into the valve outlet or safety relief valve. You may damage the valve
and cause a leak. Leaking propane may result in explosion, fire, severe personal injury, or death.
Regulator Flow Limiting Device
If you are experiencing any of the following performance issues you may have activated the flow limiting feature in your
regulator:
•
Burners not getting hot enough
•
Low or incomplete burner flames
•
Low gas pressure
•
Burners not staying lit
Resetting the Regulator Flow Limiting feature
1. With all control knobs and the gas source in the “ OFF ” position.
2. Disconnect the hose and regulator from the propane tank.
3. Turn all control knobs to the “ MAX ” position, and let stand for 1-3 minutes, allowing all excess gas in valves and
manifold to dissipate.
4.
Turn all control knobs to the “ OFF ” position.
5.
Reconnect the hose and regulator to the propane tank - Do not cross thread the connection. Hand-tighten only.
6. Check all hose connections to ensure that a positive seal has been made.
7. Slowly turn “ ON ” the propane gas supply, 1/2 to a full turn.
8. Wait approximately 5 seconds for the hose and regulator pressure to stabilize (to prevent the flow limiting device
feature from being re-activated).
9. Turn the ignition burner control knob, to the “ MAX ” position.
10. Press the electronic ignition button, or use the match and match holder, or a barbecue lighter to ignite the burner.
AVOID ACTIVATING THE FLOW LIMITING FEATURE
by following the proper start up and shut down procedures
and performing a complete leak test and safety check to ensure that there are no leaks in the system, and that a
positive connection has been made between the gas source and manifold assembly.
Connecting Regulator to the LP Cylinder
NOTE:
If you cannot complete the connection, disconnect regulator and repeat steps 4 and 5. If you are still unable to
complete the connection, DO NOT USE THIS REGULATOR!