Mellanox Grid Director 4700 Installation Manual
51
To install the Grounding Stud:
1.
Insert a 10-32 5/8" screw through the Grounding hole, rear-to-front, as shown.
2.
Add a spring washer onto the 10-32 5/8" thread, this time front-to rear.
3.
Add a nut #10.
4.
Add another spring washer.
5.
Insert the 6 AWG grounding cable. Connect the other end of the grounding cable to a
grounding point at your site.
6.
Add another spring washer. Make sure that the grounding cable is tightly secured between
the two spring washers.
7.
Secure everything with a grounding nut #10.
8.
Apply the Ground label under the grounding nut.
9.
Apply the Safety Warning label on the side of the chassis, near the grounding stud.