Meiko UPster K, Operating Instructions Manual

Page: 14 / 40

9726766 14 / 40
7.3 Installation and assembly
MEIKO created an installation drawing featuring machine dimensions as well as con-
nection and consumption values.
The system must be installed as per the information in the installation drawing. It
m u s t be installed by a licensed and authorised technician.
Assembly is completed by reference to the assembly diagram and, in general, by
following the instructions of a trained MEIKO engineer. The machine must be in-
stalled and connected by an approved professional.
For Australia only:
The equipment must be installed in accordance to AS/NZS 3500.1.
We do not accept any liability for damage caused by unprofessionally implemented
connection work.
System installation steps:
Position the unpacked machine according to the dimensions specified on the in-
stallation drawing.
Set up the machine so that it is correctly levelled and aligned.
Refer to the separate installation instructions for additional information on installa-
tion.
7.4 Floor load from the dishwashing machine
The floor load per leg (with a loaded area
Ø
=30 mm per leg) is approx. 220 kg
7.5 Requirements to the installation area

Ensure that the storage and installation area is permanently frost free.
If the system is installed in an area where the surrounding temperatures are
below 5°C, the water freezing inside may damage the internal water compo-
nents (pump, solenoid valve, etc.).

Anti-slip floor coverings must be provided in the system's work area.
7.6 Requirements to the electrical connection
DANGER
Risk of injury due to electric shock!
Work on the electrical machine components may be undertaken by specialist electri-
cians only.
General Electrical Regulations must be observed when connecting the machine to
the power supply.
The electrical cabinet features the corresponding wiring diagram. This wiring dia-
gram forms part of the machine and for this reason, it must not be removed.
There are two type plates indicating the electrical connected loads, one visible from
the outside and one on the inside of the electrical cabinet.
When connecting the power supply line to the machine, observe the general
electrical regulations