Meiko TopClean M, Instructions For Use Manual, Page: 22 / 54

22 / 54 9018116
8 Commissioning
Warning
Danger of injury from entering a danger zone
Unauthorised persons might be in or enter the danger zone during transport, as-
sembly, commissioning, maintenance and repair work. This can lead to injuries.
• Only permit qualified persons to perform work at the machine.
• Remove unauthorised persons from the danger zone.
• Cordon off danger zone and signpost it for third parties.
• Never remove or disable safety devices on the machine.
• Always wear cut-resistant protective gloves when removing housing parts and
when working inside the machine!
8.1 Check prerequisites for commissioning
Caution
Material damage due to steam emission
Small quantities of steam may escape through the cleaning and disinfection ma-
chine's door. It is possible that adjacent furniture may warp.
• Protect adjacent furniture from warping.
• If possible, avoid installing the machine in an area close to furniture susceptible
to warping.
Prerequisites to be provided by the customer:
• Consistently frost free storage and installation area.
• Firm, level ground.
• Anti-slip floor coverings installed in the work area around the cleaning and dis-
infection appliance and/or cleaning combination.
• Electrical connection in accordance with the dimensional drawing.
• Fresh water connection in accordance with the dimensional drawing.
• Compressed air connection in accordance with the dimensional drawing.
• Waste water connection in accordance with the dimensional drawing.
8.2 Perform commissioning
Note
Instruction and initial commissioning may be performed only by an authorised ser-
vice technician! The operator must not use the cleaning and disinfection appliance
before completing training.
To avoid damage or dangerous injuries during commissioning, please note the fol-
lowing points:
• Make sure that all tools and foreign parts are removed from the appliance.
• Make sure that any escaped fluids have been removed.
• For cleaning and disinfection appliances with GiO MODULE, attention must be
paid to the "Commissioning certificate for GiO MODULES" and the instructions
adhered to accordingly.