Megger ATEC 210415 Series, Manual

Page: 55 / 82

M
48
AVTM21-415Ja Rev. A June 2005
1. Visually inspect the case, noting that hinges and case locks
function properly. Check for breaks in the case or lid.
Note the condition of the carrying strap and case feet.
2. Wipe the outside of the case with the damp cloth; then dry
with a clean dry cloth.
3. Open the lid; fully extend and visually inspect all cables. If
necessary, wipe each cable with the damp cloth; then dry.
Wipe out the lead compartment. Wipe the panel and
instruction card with a clean dry cloth.
4. Visually inspect the panel, noting that all knobs are secure
on their shafts and that all controls operate smoothly
without binding.
5. Set meters mechanically to left scale end.
6. Removal of Test Set from Case
G
CAUTION
The test set must be de-energized for at least fifteen
minutes before removing from case!
The Test Set should be removed from its case only by those
trained in handling high-voltage equipment since high voltage
can be stored in components of the test set interior even after
the set has been de-energized.
To remove the test set from the case* follow the procedure
given below:
a. Set aside the ground cable.
b. Remove and save the four panel screws.
c. Raise the panel straight up to clear the case. Handle
the set only by the panel. Place the set on a clean
surface.