page 30
To set SEND MEM, move the arrow cursor against it in
COMMS sub-menu 1 and press the
ENTER
key. This will
cause a TX symbol to flash in the main display as the
memory data is now transmitted to a peripheral device.
The data is transmitted at the settings defined by
PORT. After transmission of data you will now return to
COMMS
sub-menu 1.
To set CLEAR MEM, move the arrow cursor against
it in COMMS sub-menu 1 and press the
ENTER
key.
This now erases all the data stored in the memory. The
memory counter is now reset to zero. After clearing the
memory you will now return to COMMS sub-menu 1.
Press the
ESC
key to return to page 2 of the main-menu,
and again to return to the main display.
Displays calibration information.
Tension span
Compression span
I
Initial Zero
G
Gravitational constant
Z
Current zero
This is for information only and may be required for
diagnostic purposes by your distributor.
SEND FROM MEMORY
CLEAR THE MEMORY
INFORMATION
◀▶
◀▶