Technical Manual
Motion Detector/Automatic Switch 55/63
Series .02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49-2263-4588 • [email protected] • www.mdt.de
43
43
4.5.2 Single-button function
For all functions, the "
Time for long keypress
" can be set via parameters.
When selecting "
Single-buttons function
”, the
following functions are available: switch, switch/send
values short/long (with 2 objects), dimming, blinds/shutter, send state and send value.
Important:
When " Single-button function" is activated, the basic functions for the left button as well
as for the right button always appear on the screen. Both can be configured completely freely.
In the following descriptions of the basic functions, the left button is always listed. The settings for
the right button are identical for the same function!
The individual functions are described below:
4.5.2.1 Basic function
–
Switch
Single-button function
The following figure shows the available settings:
Figure 26: Settings
–
Single-button function: Switch
With the basic function " Switch -
Subfunction: Switch when button is pressed
", the button sends
the respective fixed set value ON or OFF when pressed.
With the "
Subfunction - Toggle when button is pressed
", the button sends the respective inverted
value in relation to the last received status value. For this purpose, the status object "Status for
toggle" is connected to the status of the actuator to be controlled. If an ON-signal was received as
the last value, the button sends an OF-command the next time it is pressed.
With the "
Subfunction - Send value when button is pressed
", the set value is always sent, either as a
percentage value, decimal value, or scene.
The values that can be set are 0 - 100% (percentage value), 0 - 255 (value) or 1 - 64 (scene).
The following table shows the available communication objects:
Number
Name/Object Function
Length
Usage
131
Button left:
–
Switch
1 Bit
Switching function of the button.
Subfunction: Switch when button is pressed
131
Button left:
–
Toggle
1 Bit
Toggle function of the button.
Subfunction: Toggle when button is pressed
131
Button left:
–
send value, send percent
value, send scene
1 Byte
Sending the value. DPT depending on the
parameter setting.
Subfunction - Send value when button is pressed
132
Button left:
–
Status for toggle
1 Bit
Status to update the button. Must be linked to the
status of the actuator to be switched.
Subfunction: Toggle when button is pressed
Table 32: Communication objects
–
Single-button function: Switch
