Technical Manual
Motion Detector/Automatic Switch 55/63
Series .02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49-2263-4588 • [email protected] • www.mdt.de
12
12
The following table shows the possible settings for this menu:
ETS-Text
Dynamic range
[Default value]
Comment
Send
„Operating“ cyclically
not active
•
1 min
–
24 h
Activation of a cyclic "in operation"
telegram.
Day/Night object
•
not active
•
active, not request
•
request after reset
Definition of whether a Day/Night
object is to be used and whether
this is to be requested in the event
of a reset.
Value for Day/Night
▪
Day = 1 / Night = 0
•
Day = 0 / Night = 1
Sets the polarity for Day/Night
switching.
Toggle Day/Night
•
at next presence
•
directly at toggle
Determining when the Day/Night
switchover takes place.
Basic setting of sensitivity
Trigger sensitivity “Day”
0
–
8
[6]
Setting the triggering sensitivity in
Day/Night mode.
Sensitivity 0 (lowest level) only
possible from DB V4.4 and from
device HW R2.5.
Trigger sensitivity “Night”
0
–
8
[3]
Presence sensitivity
1
–
10
[8]
Setting the sensitivity when
presence is detected.
Basic setting of brightness
Switch-
on threshold “Day”
5
–
1000 Lux
[100]
Setting of the brightness threshold
below which the sensor is activated
in Day mode.
Switch-
on threshold “Night”
5
–
1000 Lux
[10]
Setting of the brightness threshold
below which the sensor is activated
in Night mode.
Switch-off if exceedance
•
not active
•
active
Setting whether an OFF telegram
should be sent when a certain
brightness threshold is exceeded.
Switch-
off when exceeding…
75
–
1000 Lux
[800]
Setting the brightness threshold
from when the sensor sends an
OFF telegram.
