Technical Manual
Glass Push-button II Smart & Push-button Smart 86 [Series .02]
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1 • Germany
Phone: +49-2263-
880 • [email protected] • www.mdt.de
74
74
Two communication objects are displayed for the "blinds/shutter" function: the object "Stop/Slats
Open/Close" and the
object "Blinds Up/Down “.The moving object is used to move the
blinds/shutters up and down. The stop/step object is used to adjust the slats. In addition, this
function stops the up/down movement as far as the end position has not yet been reached.
In the case of the
two-button function
, the button assignment can be set.
The table below shows the relationships:
Table 56: Functionality
–
Two-button movement blinds/shutter
With the
single-button function
, the system switches between "Up" and "Down" after each button is
pressed.
Since shutter actuators always use a "1" signal for the downward movement and a "0" signal for the
upward movement, the push-button outputs this as well.
It is also possible to swap the action for the long and short button presses. In this way, it is possible
to select whether the movement is to take place via a long or a short button press. The stop/step
object then adopts the other operating concept.
Only one object is available as "
Status for display
". It refers to the height position. A position for the
slat cannot be visualised.
Group control extra long
If the key is pressed extra long, the single blind starts moving after 0.5 s.
After another 1.5 s, the group starts with the same movement.
This activates the group function:
If Stop is then pressed briefly, all blinds stop. If the slat is adjusted with "short", the group also
adjusts the slat.
After approx. 90 s the group function is deactivated again internally and a Stop only affects the
individual channel.
MDT Single Object Control
Two-Button function
MDT Single Object Control enables a new operating concept for controlling roller shutters. For use,
the following parameter must be set to active in the
MDT Shutter Actuator
to be controlled:
Now it is possible to start the up/down movement with a short keystroke and also to stop an active
up/down movement with a short keystroke.
With the setting "Short = Up/Down/Stop / Long = Central object (MDT Single Object Control)" an
additional object is displayed, which can start the up/down movement with a long keystroke and can
also stop an active up/down movement with a long keystroke. This function can be used, for example,
to move a single shutter in a room with a short keystroke and to move the entire room with a long
keystroke.
Function Up/Down
Function Down/Up
Input
Button left
Button right
Button left
Button right
Moving object
Up
Down
Down
Up
Stop/Step object
Stop/Slats Open Stop/Slats Close
Stop/Slats Close Stop/Slats Open
