Technical Manual
Glass Push-button II Smart & Push-button Smart 86 [Series .02]
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1 • Germany
Phone: +49-2263-
880 • [email protected] • www.mdt.de
62
62
4.4.7 Temperature Shift
Two-button function
Important
: This function is only available for devices with temperature sensor!
The temperature shift can be used to move the setpoint of the heating control.
The following figure shows the available settings using the example "via 1 bit" :
Figure 31: Settings
–
Temperature shift
The table below shows all available settings:
ETS-Text
Dynamic range
[Default value]
Comment
Temperature shift
▪
1 Bit temperature shift
▪
1 Byte temperature shift
▪
2 Byte temperature shift
▪
2 Byte shift of “Basis
Comfort Setpoint”
Setting how the temperature is to be
shifted
Step width
0.
1 … 1 K
[0.5 K]
Set the step width between two send
commands.
Not visible when shift via
“
1 Bit
”
.
Lower limit
-
10 … 10 K
[-3 K]
Setting of the lower limit value for the
setpoint shift.
Only for shift via
“
1 Byte/2 Byte
”
.
Upper limit
-
10 … 10 K
[3 K]
Setting of the upper limit value for the
setpoint shift.
Only for shift via 1
“
Byte/2 Byte
”
.
Lower limit
0 … 45 °C
[19 °C]
Setting of the lower limit value for the
setpoint shift.
Only
for “2 Byte shift of “Basi
c
Comfort s
etpoint”.
Upper limit
0 … 45 °C
[23 °C]
Setting of the upper limit value for the
setpoint shift.
Only for “2 Byte shift of “Basi
c
Comfort s
etpoint”.
Repeated sending at
pressed key
▪
not active
▪
active
Setting whether the shift should be
repeated at fixed intervals while the
key is held
Repetition time
200 ms
–
3 s
[1 s]
Sets the time between two telegrams
of the temperature shift when
repetition is activated
