theONE
TM
Atmospheric Generator
theONE
TM
User Guide, Rev: A/f
33 / 45
XLR
Quick release pin
Rotate the fan to have the configuration icon on top of
the fan, and slightly incline the fan to have a downstream
dispersion. Be careful to tighten the two handlewheels on
both sides.
Connect the three (3) contacts XLR cable to the MDG theONE’s front
receptacle.
Downward dispersion
Mount the fan above the fog nozzle for downward fog
dispersion.
Just pin the fan at the position below the nozzle. Verify
the fan support is horizontal, and insert the quick release
pins on both sides.
Attach the safety cable. We recommend having the safety
cable passing inside the fan support, then several times
around structural tube.
Rotate the fan to have the configuration icon on top of the fan, and slightly incline
the fan to have a downstream dispersion. Be careful to tighten the two handlewheels
on both sides.
Connect the three (3) contacts XLR cable to the
MDG theONE
’s front receptacle.
Transportation
When the external fan is not used, it can be stored under
the
MDG theONE
generator.
DO NOT FORGET TO DISCONNECT THE XLR cable, and to
remove the quick release pins.
Insure that the fan is horizontal, and place the XLR cable
inside the fan support.
Slide the fan below the fog generator, with the metal
hinge on top until you see two holes on the support
plate. If you feel some resistance, pull upward the back
of the fan.
Insert the quick release pins in the two holes of the support plate.
Attach the safety cable as shown on the picture.
Quick release pin
Safety cable
Support plate
Hinge on top
This icon on top
