4 - 8
Operation
DataLogger Operation
DataLogger Facing
The Datalogger Facing screen has controls for the facer and indexer. The hydraulic pressure controls are available to operate the
carriage and have the ability to select between the 3 hydraulic pressures.
NOTICE:
The indexer must be calibrated before the first facing operation of the work day to ensure the interlock's location is set to
prevent accidental crashing of the indexer components against the components of the vehicle.
To calibrate the indexer position, refer to the Set Up Talon 2000 section of this manual.
Facing the Pipe:
Å
Ensure the carriage is closed and the facer is in the start position.
If the facer is not in the start position, open the carriage and touch the facer start position button to send the
facer cutter to the start position. Close the carriage against the facer stops.
Å
Touch the facer start button to start the facer operation. Touch the facer start button again to pause the facing
operation. Pausing the facing operation will stop the cutter in its current location. The cutter will still rotate while
paused.
If there are any issues with the facing operation, touch the facer abort button to abort the facing operation.
Å
After the facing operation is complete, Open the carriage and index right slightly.
If the face off is not complete, reload pipe and repeat facing procedures
Å
Touch the facer home button to send the facer to the home position.
PH05
49
7-0
4-1
5-1
6
