9
10.
AIR GAP
Using a feeler guage, measure the air gap between the
flywheel and the coil. The measurement should be
between .08”-.010”. Loosen the mounting screws to
adjust the air gap. See Figure 29.
11.
FLYWHEEL REMOVAL
IMPORTANT:
If any of the air fins on the fly-
wheel break off for any reason, a serious imbal-
ance and resulting vibration and damage to the
engine will occur.
11.1. Remove the spark plug from the engine.
11.2. Place a length of starter cord into the spark plug
opening. This will ease removal of the flywheel.
11.3. Using a T-25 Torx wrench, remove the four
screws attaching the starter housing assembly to
the housing assembly.
11.4. Remove the housing from the unit.
Figure 29
.08”-.010” Air Gap
11.5. Using a 13mm socket,
loosen but do not
remove
the nut securing the flywheel to the
crankshaft. See Figure 30.
11.6. Unthread the nut until it is flush will the end of
the drive shaft.
Figure 30
Hex Nut