3
3.2.
Using a medium Phillips screwdriver, remove the
2 screws that hold the spark arrester cover to the
muffler. See Figure 6.
3.3.
Discard the used spark arrester screen and
replace it with a new one.
3.4.
Reasemble the muffler components and install
the muffler to the cylinder. Tighten securely.
4.
SPARK PLUG
NOTE:
NOTE: For efficient operation of the saw
engine, spark plug must be kept clean and prop-
erly gapped.
4.1.
Push STOP switch down.
4.2.
Remove the shroud. See AIR FILTER Section.
4.3.
Disconnect the wire connector from the spark
plug by pulling and twisting at the same time
Figure 6
4.4.
Using the scrench, remove the spark plug. See
Figure 7.
4.5.
Check electrode gap with wire feeler gauge and
set gap to .025" (.635mm) if necessary.
4.6.
Reinstall a new spark plug.
NOTE:
A resistor spark plug must be used for
replacement (McCulloch part no. 9295-310502).
NOTE:
This spark ignition system meets all
requirements of the Canadian Interference-
Causing Equipment Regulations.
5.
REMOVAL OF BRAKE ASSEMBLY
5.1.
Disconnect the spark plug wire from the engine.
5.2.
Using a 5/8” socket, remove the nut attaching
the cover to the unit. See Figure 8.
Figure 7
Scrench
Figure 8
Hex Nut
Torx Screw
