11
12.9. Using a small flat bladed screwdriver, pry the
fuel line from the carburetor inlet. See Figure 35.
12.10.Lift up on the choke lever to remove the rubber
grommet from the housing. See Figure 36.
Figure 35
Fuel Line
Figure 36
Rubber Grommet
Choke Lever
12.11. Pry the choke handle from the carburetor. See
NOTE:
In order to remove the throttle cable from
the carburetor it will be necessary to remove the
left side of the handle assembly and create slack
in the cable.
12.12.Using a T-25 Torx driver, remove the four screws
securing the handle halves.
12.13.Remove the left handle half.
12.14.Raise up on the trigger assembly enough to
allow removal of the throttle cable from the trig-
ger. See Figure 38.
12.15.Push the throttle cable and housing towards the
saw body.
Figure 37
Choke Lever
Figure 38
Throttle Cable
