7
8.9.
Remove the brass pump housing from the oil
pipe. See Figure 21.
NOTE:
The small hole in the brass pump hous-
ing must be facing up into the upper oil hose dur-
ing assembly. The flats on the pump housing
align with the molded tabs on the housing.
NOTE:
Replace the felt washer any time you
service the chain oiler. See Figure 22.
8.10. Torque the nut securing the clutch drum assem-
bly to the crankshaft to during assembly.
Figure 21
Pump Housing
Figure 22
Felt Washer
9.
STARTER SERVICING
9.1.
Using a T-25 Torx wrench, remove the four
screws attaching the starter housing assembly to
the housing assembly. See Figure 23.
9.2.
Remove the housing from the unit.
9.3.
Use a screwdriver to lift the starter cord from
around the pulley and unwind the starter cord.
This takes tension off the starter pulley. See Fig-
ure 24.
Figure 23
Torx Screws
Figure 24
Starter Cord