
MECHANICAL
01-10–70
5. Install the oil pump chain and balancer shaft sprocket as a single unit while aligning the alignment marks on
each sprocket and oil pump chain as shown in the figure.
6. Temporarily tighten the balancer shaft sprocket installation bolt.
7. Install the oil pump chain tensioner.
Caution
•
At this stage, do not remove the wire or paper clip installed to the oil pump chain tensioner.
8. Hold the crankshaft using the
SST
.
9. Tighten the oil pump driven sprocket installation
bolt.
Tightening torque
20—30 N·m {2.1—3.0 kgf·m, 15—22 ft·lbf}
10. Tighten the balancer shaft sprocket installation
bolt.
Tightening torque
38—46 N·m {3.9—4.6 kgf·m, 29—33 ft·lbf}
11. Remove the wire or paper clip installed to the oil
pump chain tensioner and apply tension to the oil pump chain.
•
If a new oil pump chain tensioner is used, remove the installed stopper.
OIL PUMP DRIVE
SPROCKET
ALIGNMENT MARK
KEY
OIL PUMP CHAIN ALIGNMENT
MARK (ORANGE)
OIL PUMP CHAIN
ALIGNMENT
MARK (YELLOW)
BALANCER SHAFT
SPROCKET
ALIGNMENT MARK
bpe1ze00000072
49 E011 1A0
bpe1ze00000096
1A36-1U-12L.book 70 ページ 2012年12月10日 月曜日 午前9時25分