Mazda CX-9 2021, Manual

Page: 115 / 720

Use the following procedure to change
the setting.
1. Switch the ignition off and close all
of the doors and the liftgate.
2. Open the driver's door.
3. Within 30 seconds of opening the
driver's door, press and hold the
UNLOCK button on the key for 5
seconds or longer (the sound of the
doors locking/unlocking can be
heard).
After this, the system switches the
setting of pressing the driver's
request switch once or twice to
unlock all doors and the liftgate
each time the UNLOCK button is
pressed (the sound of the doors
locking/unlocking can be heard).
4. The setting change is completed by
doing any one of the following:

Switching the ignition to ACC or
ON.

Closing the driver's door.

Opening the liftgate.

Not operating the key for ten
seconds.

Pressing any button except the
UNLOCK button on the key.

Pressing a request switch.

Confirm that all doors and the liftgate
are securely locked.
For the liftgate, move it without pressing
the electric liftgate opener to verify that
the liftgate has not been left ajar.

All doors and the liftgate cannot be
locked when any door or the liftgate is
open.

It may require a few seconds for the
doors to unlock after the request switch
is pressed.

A beep sound is heard for confirmation
when the doors and the liftgate are
locked/unlocked using the request
switch. If you prefer, the beep sound can
be turned off.
The volume of the beep sound can also
be changed.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
Use the following procedure to change
the setting.
1. Switch the ignition off and close all
of the doors and the liftgate.
2. Open the driver's door.
3. Within 30 seconds of opening the
driver's door, press and hold the
LOCK button on the key for 5
seconds or longer (All of the doors
and the liftgate are locked and
unlocked when the LOCK button on
the key is pressed and held for 5
seconds.).
The beep sound activates at the
currently set volume. The setting
changes each time the LOCK button
on the key is pressed and the beep
sound activates at the set volume. (If
the beep sound has been set to not
activate, it will not activate.)
4. The setting change is completed by
doing any one of the following:

Switching the ignition to ACC or
ON.

Closing the driver's door.

Opening the liftgate.

Not operating the key for ten
seconds.

Pressing any button except the
LOCK button on the key.

Pressing a request switch.

(With theft-deterrent system)
Before Driving
Doors and Locks
3-15
CX-9_8JK1-EA-20G_Edition2_old 2020-7-20 17:31:45