REQUIRED TOOLS
• 10mm Socket Wrench
• Scissors
• Torque Wrench
• Taped Flathead Screwdriver
• Mat
• Electrical Tape
• Panel Removal Tool
• Soft clean cloth
• Squeegee
• Glass Cleaner • Nipper
• Pliers
• Primer (3M Promoter-4298)
• IPA (Isopropyl alcohol) • Phillips Screwdriver
3. BEFORE INSTALLATION
4. CONNECTION USING ELECTRO-TAP
Branch connection procedure using electro tap.
1. Insert the vehicle wiring harness into the electro tap.
2.
Fold the electro tap as shown in the figure and lock it.
WARNING
When the negative battery cable
is connected during operation, it
may cause electric shock or other
personal injuries. Disconnect the
negative battery cable before
removal/installation.
When connecting or disconnecting
connectors, grasp the connectors,
not the wires. Otherwise a short,
an accident from poor contact or
fire may occur.
Do not pull the harness with
excessive force. Doing so can
cause a breakage or a short-
related accident, as well as an
electrical short or fire.
Park the vehicle on a level ground.
Set the vehicle on park (P) and
apply the parking brake. Be sure to
turn the ignition switch off, otherwise
the vehicle can move, causing
personal injury or vehicle damage.
CAUTION
Using improper tools may cause
damage and or broken parts.
Use the correct tool for the job.
Wrap protective tape around
screwdrivers and fastener
removal tools to prevent
scratching the vehicle.
Put the removed parts and the
parts in the kit on the protective
sheet to prevent scratches.
Excessive length of wire tie may
interfere with other parts and
cause damage. Cut unnecessary
part up to about 5 mm {0.19 in}
from the fixed point.
•
When the negative battery cable is removed, the clock, radio, trip meters and other memories will be erased.
Make sure to record the content of the memory.
•
Refer to the Workshop Manual for removal and installation of vehicle parts. Not following the procedures for
removal/installation in the Workshop Manual could result in an accident or vehicle malfunction.
WORKSHOP
MANUAL
1
2
3
4
5
Electro tap
Vehicle wiring harness
Vehicle wiring harness
Harness
Terminal
Firmly press using pliers
Lock
Vehicle wiring harness
3. Insert the harness to the end of the electro tap.
4.
Firmly press the electro tap terminal using pliers.
5. Fold the electro tap in the direction of the arrow shown in
the figure and lock it.
•
Firmly engage the lock part until a click sound is heard.
Caution
4
