Make sure of the following conditions:
1. In possession of 2 Advanced Keys that are already registered to the vehicle.
2. Do not open any doors during MMS registration procedure.
Steps
MMS Registration Procedure
Response
when
successful
Response
when it fails
1
Connect the negative battery cable and close the hood.
Enter vehicle's passenger side and close the door.
•
MMS Harness LED lights up, wait 30 seconds until the LED light
turns off
30
Seconds
2
2X
Within
10 Seconds
Connect and disconnect the RES Diagnostic Connectors twice
within 10 seconds.
• MMS Harness LED makes 2 flashes.*
If the MMS Harness LED did not flash, thi
s procedure has failed.
•
Disconnect the battery and start over from step 1.
2X
3
ON
Hold up the Advanced Key over the Start Button switch, then
press the Start Button with the Advanced Key twice to the ON
position.
•
Security indicator turns ON for 3 seconds, then turns off
If Security indicator does not turn ON, this procedure has failed.
•
Disconnect the battery and start over from step 1.
OFF
Security Indicator
ON for 3 Seconds
OFF
4
Within 4 seconds of the security indicator turning off, press
the
Start Button with the Advanced Key to the OFF position.
• The Security indicator flashes.
I
f Security indicator does not flash,
this procedure has failed.
•
Disconnect the battery and start over from step 1.
Security Indicator
Flashing
OFF
5
Repeat steps 3 and 4 for the 2nd Advanced Key.
6
Connect for
3 Seconds
After both Advanced keys have been authenticated, connect the
RES Diagnostic Connectors for at least 3 seconds then disconnect.
Observe the number of flashes from the MMS Harness LED.
• MMS Harness LED flash 2 times and Start Button light will turn
ON automatically for a few seconds then shuts off, indicating a
successful registration. Proceed to next section MMS Check Mode.
If this procedure failed, the ignition switch stays OFF. Look at the
table below to determine the cause of failed registration.
• Check and fix the cause of failed registration.
•
Disconnect the battery and start over from step 1.
2X
ON
1,3,4,5,6,7
OFF
# of LED Flashes Cause of Failed Registration
1
Missed operation or step
3
3 or more Advanced Keys are already registered
4
Vehicle condition is not satisfied or MMS ECU is already registered (proceed to MMS Check Mode)
5
Time limit have elapsed
6
Advanced Keys are not registered.
7
Communication error between MMS and SSU.
*If LED makes 5 flashes on step 2, refer to table above for 3 flashes.
[After a successful MMS registration, proceed to next section for MMS Check Mode]
9. MMS REGISTRATION PROCEDURE
Steps 3 - 6 must be completed within 60 seconds of completion of Step 2.
20
