Vehicle front
Hood switch harness (Black)
Electro tap and
electrical vinyl tape
Vehicle wiring harness
18 pin connector
Type B
Terminal: B (Black)
Hood switch harness (Black)
[Vehicle wiring harness 18 pin connector]
(Connector viewed from wiring harness side)
B
Vehicle front
Hood switch harness
Vehicle wiring harness
Wire tie (Black)
Vehicles with wiring harness terminal B (Black) shown in
figure (Type B)
18. Branch connect the Hood Switch harness (Black) to the
vehicle wiring harness 18 pin connector (terminal B (Black))
using an Electro tap, and wrap the Electro tap using
electrical tape.
Please note caution for step 17-18 above.
19. Route the Hood Switch harness along the vehicle wiring
harness and secure it with 1 wire tie (black).
Vehicle front
Vehicle wiring harness
18 pin connector
Hood switch harness (White)
Insert Terminal
Insert hood switch harness (White)
terminal to empty terminal.
[Vehicle wiring harness 18 pin connector]
(Connector viewed from wiring harness side)
16. Insert the Hood switch harness (White) terminal to the
empty terminal of the Vehicle wiring harness 18 pin
connector (terminal N).
Vehicles with wiring harness terminal A (Black) shown in
figure (Type A)
17. Connect the Hood Switch harness (Black) to the vehicle
wiring harness 18 pin connector (terminal A (Black)) using
an Electro tap, and wrap the Electro tap with electrical tape.
• If there is no vehicle wiring harness (Black) in the specified
position, do not perform Step 17, skip to Step 18.
Note
Vehicle front
Hood switch harness (Black)
Electro tap and
electrical vinyl tape
Vehicle wiring harness
18 pin connector
Type A
Terminal: A (Black)
Hood switch harness (Black)
[Vehicle wiring harness 18 pin connector]
(Connector viewed from wiring harness side)
<Terminal insertion procedure>
Terminal
Retainer
Terminal
<Terminal insertion procedure>
(b) Insertion terminal
(a) Remove retainer
(c) Reinstall retainer
Retainer
Terminal
Terminal
•
When connecting a terminal to a connector, always refer
to the following, <Terminal insertion procedure>.
• Connect the harness terminal to the specified signal line
because a system or vehicle malfunction may occur if it
is connected incorrectly.
• Connect the electro tap to the specified signal line because
a system or vehicle malfunction may occur if it is connected
incorrectly.
•
For branch connection procedure using electro tap, refer to
[4. CONNECTION USING ELECTRO TAP] on page 4.
Caution
Caution
12
